轉輪除濕機是降低空氣的含濕，獲取了單調空氣常用的除濕設備。它是利用了涂覆在緩慢旋轉的多孔道輪狀或環狀載體上的吸濕劑來吸附透過該轉輪的濕空氣中所含的水蒸氣分子；吸濕后的吸濕劑可在高溫下脫水再生，恢復吸濕才調。其時仍在運用已被外廠家挑選的紙制氯化鋰吸濕轉輪，除濕功率低、能耗高、壽命短。

　　轉輪除濕機的運用，是有一定環境需要的，通常來講要有以下這些：

　　(1)除濕機與障礙物之間、應當堅持一定的間隔，并留有一定的空間。

　　(2)除濕機不能放在低于處理空氣露點的環境中，防止其內部出現結露表象。

　　(3)除濕機的運用環境中、應當有卓的通風，不能有塵土、油污等，更不能有腐蝕性或許危險性的氣體或物品。

　　(4)除濕機應設排水設備，以便當冷凝水的排放。

　　除濕機的操作規程，對它來講也是很要的一個有些，其要內容有：

　　(1)除濕機安裝好往后、應當查看其是不是處于水平狀況。

　　(2)除濕機的電氣聯接、應當由業人員進行，防止出現問題。

　　(3)除濕機所運用的電源電壓，應當符合規定需要。

　　(4)除濕機的工作和接連，不能通過電源的插拔來結束，這樣對設備的損害是很大的。

　　(5)除濕機的放置是不是水平，給水是不是疏通，以及電源的運用是不是常。

　　(6)除濕機假定長期不用的話、那么應當拔下電源插頭，防止發作電消耗。

　　英文版：Rotary desiccant is to reduce the humidity of the air, to obtain the monotonous air commonly used in the desiccant equipment. It is the use of the coating in the slowly rotating porous wheel or ring carrier on the hygroscopic agent for the adsorption of water vapor molecules contained in the air through the wet runner; hygroscopic agent can be regenerated after moisture absorption dehydration under high temperature, moisture absorption and recovery ability. It is still in the use of foreign manufacturers has been selected paper lithium chloride absorption dehumidification runner, low power, high energy consumption, short service life.

　　The use of rotary wheel, there is a certain environmental needs, usually the first to have the following:

　　(1) between the desiccant and obstacles, should adhere to a certain distance, and have a certain space.

　　(2) the dehumidifier can not be placed in the lower air dew point in the environment, to prevent the internal condensation phenomenon.

　　(3) the use of the environment in the environment, there should be excellent ventilation, can not be dust, oil, etc., but also can not be corrosive or dangerous gases or goods.

　　(4) the drainage equipment should be set up to facilitate the discharge of condensed water.

　　The operating procedures of the desiccant, it is also a very important part of some of its primary content:

　　(1) after the installation of the machine, it is necessary to check whether it is in a horizontal position.

　　(2) the electrical connection of the desiccant, shall be carried out by professional personnel to prevent problems.

　　(3) the use of the power supply voltage, should meet the requirements.

　　(4) the work of the desiccant and a series, can not be through the power of the plug to end, so the damage to the equipment is very large.

　　(5) the placement of the desiccant is not a level, the water is not clear, and the use of power is not normal.

　　(6) if the unit is not in use for a long time, it should unplug the power plug and prevent the power consumption.